ZyXEL Communications XGS4600 Series - System Information Stacking Hardware Monitor

XGS4600 Series User’s Guide
86
8.2.1 System Information Stacking Hardware Monitor
Click a slot number in the System Information screen to display more detailed hardware information on
a Switch.
Figure 65 Basic Setting > System Info > Hardware Monitor (Stacking Mode)
Status Normal indicates that the voltage is within an acceptable operating range at this point;
otherwise Error is displayed.
Power Source This field lists the power supply modules installed in the Switch. PSU_1 is PWR1, and PSU_2 is PWR2.
Status Active indicates the Switch is currently operating from the power source to which the power
module is connected.
Standby indicates the power module is connected to a power source but the Switch is NOT
operating from it.
N/A is displayed when the power module is not connected to a power source and there is no
available power.
Hardware Status (Stacking Mode)
Slot This number identifies the Switch in the stack. Click the number to see more detailed information
on the Switch.
Name This is the system name of the Switch in the stack.
Voltage This shows if the power supply voltage sensor is within normal tolerance range.
Temperature This shows if the temperature sensors on the Switch printed circuit board are within normal
tolerance range.
Fan This shows if the fan sensors are within normal tolerance range.
Power Source This shows if the Switch is properly operating from the connected power source.
Table 14 Basic Setting > System Info (continued)
LABEL DESCRIPTION