Chapter 40 Link Layer Discovery Protocol (LLDP)
XGS4600 Series User’s Guide
397
Figure 317 Advanced Application > LLDP > LLDP-MED Network Policy (Standalone Mode)
Figure 318 Advanced Application > LLDP > LLDP-MED Network Policy (Stacking Mode)
The following table describes the labels in this screen.
Table 180 Advanced Application > LLDP > LLDP-MED Network Policy
LABEL DESCRIPTION
Port Enter the port number to set up the LLDP-MED network policy. You can enter multiple ports
separated by (no space) comma (,) or hyphen for a range. For example, enter “3–5” for
ports 3, 4, and 5. Enter “3,5,7” for ports 3, 5, and 7.
In stacking mode, the first number represents the slot and the second the port number. Enter
1/1–1/24,2/23 for ports 1 to 24 for the Switch in slot 1 and port 23 for the Switch in slot 2, for
example.
Application Type Select the type of application used in the network policy.
• voice
• voice-signaling
•guest-voice
• guest-voice-signaling
• softphone-voice
• video-conferencing
• streaming-video
• video-signaling
Tag Select to tag or untag in the network policy.
•tagged
• untagged
VLAN Enter the VLAN ID number. It should be from 1 to 4094. For priority tagged frames, enter “0”.
To Next Page
Loading...
