ABB 800xA - Page 173

Section 7 I/O Displays PROFIBUS Device Display
3BUR002418-600 A 173
PROFIBUS Device Status Area
The PROFIBUS Device area shows the device state and contains a button to display
device diagnostics and information. Select the PROFIBUS Device box to select the
Get Diagnostics or Get Device Info display, Figure 76.
Name The controller subsystem part of the logical name created during
database configuration.
Lan This field represents the number of the Local Area Network (LAN)
for all the stations shown. For the AC 460 this is LAN # 1 - 4.
Go back to the controller display to select a different LAN.
Device This field represents the device number.
Go back to the LAN display to select a different device.
Templet The logical device name created during database configuration is
given in this field.
Label Descriptive label associated with templet.
State This field shows the status of the device.
ACTIVE indicates the
device is in use.
READY indicates a transient state on the way to becoming
ACTIVE.
FAILED means the
device has stopped.
MISSING means there is not an
device connected.
UNKNOWN is an indeterminate state, sometimes seen as a
transient state as the station changes state.
Get
Diagnostics
Select this to get vendor specific device-related diagnostic codes,
Figure 76. You may also get vendor specific device diagnostics by
selecting the device detail. See the vendor’s documentation to
interpret device-related diagnostic hexadecimal codes.
Get Device
Info
Select this to get device information,
Figure 76.