ABB ACS880 N5700 Series - Page 201

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
6Bit 1 of 6.17 Drive status word 2 (page 154).Magnetized
7Bit 6 of 6.16 Drive status word 1 (page 153).Running
8Bit 2 of 6.11 Main status word (page 153).Ready ref
9Bit 8 of 6.11 Main status word (page 153).At setpoint
10Bit 2 of 6.19 Speed control status word (page 155).Reverse
11Bit 0 of 6.19 Speed control status word (page 155).Zero speed
12Bit 10 of 6.17 Drive status word 2 (page 154).Above limit
13Bit 7 of 6.11 Main status word (page 153).Warning
14Bit 3 of 6.11 Main status word (page 153).Fault
15Inverted bit 3 of 6.11 Main status word (page 153).Fault (-1)
16Bit 13 of 6.16 Drive status word 1 (page 153).Start request
22Bit 0 of 44.1 Brake control status (page 362).Open brake
command
23Bit 11 of 6.16 Drive status word 1 (page 153).Ext2 active
24Bit 9 of 6.11 Main status word (page 153).Remote control
33Bit 0 of 32.1 Supervision status (page 328).Supervision 1
34Bit 1 of 32.1 Supervision status (page 328).Supervision 2
35Bit 2 of 32.1 Supervision status (page 328).Supervision 3
40Bit 0 of 10.99 RO/DIO control word (page 179).RO/DIO control
word bit0
41Bit 1 of 10.99 RO/DIO control word (page 179).RO/DIO control
word bit1
42Bit 2 of 10.99 RO/DIO control word (page 179).RO/DIO control
word bit2
43Bit 8 of 10.99 RO/DIO control word (page 179).RO/DIO control
word bit8
44Bit 9 of 10.99 RO/DIO control word (page 179).RO/DIO control
word bit9
See Terms and abbreviations (page 130).Other [bit]
Not energized /
uint32
(Visible when 14.1 Module 1 type = FIO-01)
Selects a drive signal to be connected to digital
input/output DIO1 of the extension module when
parameter 14.9 DIO1 function is set to Output.
DIO1 output source14.11
0Output is not energized.Not energized
1Output is energized.Energized
2Bit 1 of 6.11 Main status word (page 153).Ready run
4Bit 0 of 6.16 Drive status word 1 (page 153).Enabled
5Bit 5 of 6.16 Drive status word 1 (page 153).Started
6Bit 1 of 6.17 Drive status word 2 (page 154).Magnetized
7Bit 6 of 6.16 Drive status word 1 (page 153).Running
Parameters 201