ABB ACS880 N5700 Series - Page 202

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
8Bit 2 of 6.11 Main status word (page 153).Ready ref
9Bit 8 of 6.11 Main status word (page 153).At setpoint
10Bit 2 of 6.19 Speed control status word (page 155).Reverse
11Bit 0 of 6.19 Speed control status word (page 155).Zero speed
12Bit 10 of 6.17 Drive status word 2 (page 154).Above limit
13Bit 7 of 6.11 Main status word (page 153).Warning
14Bit 3 of 6.11 Main status word (page 153).Fault
15Inverted bit 3 of 6.11 Main status word (page 153).Fault (-1)
16Bit 13 of 6.16 Drive status word 1 (page 153).Start request
22Bit 0 of 44.1 Brake control status (page 362).Open brake
command
23Bit 11 of 6.16 Drive status word 1 (page 153).Ext2 active
24Bit 9 of 6.11 Main status word (page 153).Remote control
33Bit 0 of 32.1 Supervision status (page 328).Supervision 1
34Bit 1 of 32.1 Supervision status (page 328).Supervision 2
35Bit 2 of 32.1 Supervision status (page 328).Supervision 3
40Bit 0 of 10.99 RO/DIO control word (page 179).RO/DIO control
word bit0
41Bit 1 of 10.99 RO/DIO control word (page 179).RO/DIO control
word bit1
42Bit 2 of 10.99 RO/DIO control word (page 179).RO/DIO control
word bit2
43Bit 8 of 10.99 RO/DIO control word (page 179).RO/DIO control
word bit8
44Bit 9 of 10.99 RO/DIO control word (page 179).RO/DIO control
word bit9
See Terms and abbreviations (page 130).Other [bit]
0.00 s / real32(Visible when 14.1 Module 1 type = FDIO-01)
Defines the activation delay for digital input DI1.
*DI status
**Delayed
DI status
t
On
t
Off
t
On
t
Off
Time
1
0
1
0
t
On
= 14.12 DI1 ON delay
t
Off
= 14.13 DI1 OFF delay
*Electrical status of DI or status of selected source (in
output mode). Indicated by 14.5 DI status.
**Indicated by 14.6 DI delayed status.
DI1 ON delay14.12
10 = 1 s / 100 = 1 sActivation delay for DI1.0.00 ... 3000.00 s
202 Parameters