ABB ACSM1 - Page 141

Parameters and firmware blocks
141
16.09 USER SET SEL FW block: None
Enables the save and restoration of up to four custom sets of parameter settings.
The set that was in use before powering down the drive is in use after the next power-up.
Note: Any parameter changes made after loading a user set are not automatically stored into the
loaded set – they must be saved using this parameter.
(1) No request Load or save operation complete; normal operation.
(2) Load set 1 Load user parameter set 1.
(3) Load set 2 Load user parameter set 2.
(4) Load set 3 Load user parameter set 3.
(5) Load set 4 Load user parameter set 4.
(6) Save set 1 Save user parameter set 1.
(7) Save set 2 Save user parameter set 2.
(8) Save set 3 Save user parameter set 3.
(9) Save set 4 Save user parameter set 4.
(10) IO mode Load user parameter set using parameters 16.11 and 16.12.
16.10 USER SET LOG FW block: None
Shows the status of the user parameter sets (see parameter 16.09 USER SET SEL). Read-only.
N/A No user sets have been saved.
(1) Loading A user set is being loaded.
(2) Saving A user set is being saved.
(4) Faulted Invalid or empty parameter set.
(8) Set1 IO act User parameter set 1 has been selected by parameters 16.11 and
16.12.
(16) Set2 IO act User parameter set 2 has been selected by parameters 16.11 and
16.12.
(32) Set3 IO act User parameter set 3 has been selected by parameters 16.11 and
16.12.
(64) Set4 IO act User parameter set 4 has been selected by parameters 16.11 and
16.12.
(128) Set1 par act User parameter set 1 has been loaded using parameter 16.09.
(256) Set2 par act User parameter set 2 has been loaded using parameter 16.09.
(512) Set3 par act User parameter set 3 has been loaded using parameter 16.09.
(1024) Set4 par act User parameter set 4 has been loaded using parameter 16.09.