ABB ACSM1 - Page 181

Parameters and firmware blocks
181
DI4 Digital input DI4 (as indicated by 2.01 DI STATUS, bit 3).
DI5 Digital input DI5 (as indicated by 2.01 DI STATUS, bit 4).
DI6 Digital input DI6 (as indicated by 2.01 DI STATUS, bit 5).
RO1 Relay output RO1 (as indicated by 2.02 RO STATUS, bit 0).
RO2 Relay output RO2 (as indicated by 2.02 RO STATUS, bit 1).
RO3 Relay output RO3 (as indicated by 2.02 RO STATUS, bit 2).
RO4 Relay output RO4 (as indicated by 2.02 RO STATUS, bit 3).
RO5 Relay output RO5 (as indicated by 2.02 RO STATUS, bit 4).
Running Bit 3 of 6.01 STATUS WORD 1 (see page 120).
Const Constant and bit pointer settings (see Bit pointer parameter on page
89).
Pointer
33.18 BIT1 INVERT SRC FW block: None
Selects the source bit whose inverted value is shown by 6.17 BIT INVERTED SW, bit 1. For the
selections, see parameter 33.17 BIT0 INVERT SRC.
33.19 BIT2 INVERT SRC FW block: None
Selects the source bit whose inverted value is shown by 6.17 BIT INVERTED SW, bit 2. For the
selections, see parameter 33.17 BIT0 INVERT SRC.
33.20 BIT3 INVERT SRC FW block: None
Selects the source bit whose inverted value is shown by 6.17 BIT INVERTED SW, bit 3. For the
selections, see parameter 33.17 BIT0 INVERT SRC.
33.21 BIT4 INVERT SRC FW block: None
Selects the source bit whose inverted value is shown by 6.17 BIT INVERTED SW, bit 4. For the
selections, see parameter 33.17 BIT0 INVERT SRC.
33.22 BIT5 INVERT SRC FW block: None
Selects the source bit whose inverted value is shown by 6.17 BIT INVERTED SW, bit 5. For the
selections, see parameter 33.17 BIT0 INVERT SRC.