ABB Advant Controller 450 User Manual

Advant
®
Controller 450 User’s Guide
Section I.3 List of System Messages and Corrective Actions
3BSE 002 415R701 Rev A I-11
22 12 110
111
112
113
114
115
116
117
118
119
120
121
122
127
128
129
130
131
132
133
134
137
138
139
141
142
The address jumpering of the positioning board and the
I/O address given on the PC element FREQ-MP are
different.
The I/O address given on the PC element FREQ-MP is
odd.
POS-A reactivated
POS-O reactivated
POS-L reactivated
PULSE-S reactivated
FREQ-SP-reactivated
FREQ-MP reactivated
DSDP board reactivated
DSDP out of order
Incorrect address in PC element, the address is too
high or too low (POS-A, POS-L, POS-O, FREQ-SP,
FREQ-MP, COUNT-DP).
Incorrect address in the PC element
Incorrect address to MV 100 unit
MV 100 controller out of order
MV 100 controller in order
MV 100 unit out of order
MV 100 unit in order
DSDC board out of order
Fault on DSDC board
Fault on DSDC board
DSDC board reactivated
DSXW board out of order
DSXW board reactivated
Fault on DSXW board
DSDP 170 board in working order
DSDP 170 board out of order
13 100
101
Free-programmable module out of order
Free-programmable module active
20 102 Item designation pointed out by data base element
START is not a CONTRM.
Table I-9. Type 22, Code 9, 12, 13 and 20 (Continued)
Type Code Significance Data 1 Comments/Actions

ABB Advant Controller 450 Specifications

General

Brand	ABB
Model	Advant Controller 450
Category	Controller
Language	English