ABB DCS550 - Page 187

187
Signal and parameter list
3ADW000379R0501 DCS550 Manual e e
Signal / Parameter name
min.
max.
def.
unit
10.22 DynBrakeAck (dynamic braking acknowledge)
The drive sets
A105 DynBrakeAck [AlarmWord1 (9.06) bit 4] if a digital input for dynamic braking is selected
and the acknowledge (dynamic braking active) is still present when
On [UsedMCW (7.04) bit 3] is set.
Selections see
MainContAck (10.21).
A105 DynBrakeAck
[AlarmWord1 (9.06)
bit 4] should prevent the drive to be started while dynamic braking is
active.
Int. Scaling: 1 == 1 Type: C Volatile: N
NotUsed
DI11
NotUsed
-
10.23 DC BreakAck (DC breaker acknowledge)
The drive sets
A103 DC BreakAck [AlarmWord1 (9.06) bit 2] if a digital input for the DC-breaker is selected
and the acknowledge is mi
ssing. Selections see MainContAck (10.21).
The motor will coast if
A103 DC BreakAck [AlarmWord1 (9.06) bit 2] is set.
Int. Scaling: 1 == 1 Type: C Volatile: N
NotUsed
DI11
NotUsed
-
10.24 Unused
10.25 DI1Invert (invert digital input 1)
Inversion selection for digital input 1:
0 =
Direct
1 =
Inverted
Int. Scaling: 1 == 1 Type: C Volatile: N
Direct
Inverted
Direct
-
10.26 DI2Invert (invert digital input 2)
Inversion selection for digital input 2:
0 =
Direct
1 =
Inverted
Int. Scaling: 1 == 1 Type: C Volatile: N
Direct
Inverted
Direct
-
10.27 DI3Invert (invert digital input 3)
Inversion selection for digital input 3:
0 =
Direct
1 =
Inverted
Int. Scaling: 1 == 1 Type: C Volatile: N
Direct
Inverted
Direct
-
10.28 DI4Invert (invert digital input 4)
Inversion
selection for digital input 4:
0 =
Direct
1 =
Inverted
Int. Scaling: 1 == 1 Type: C Volatile: N
Direct
Inverted
Direct
-
10.29 DI5Invert (invert digital input 5)
Inversion selection for digital input 5:
0 =
Direct
1 =
Inverted
Int. Scaling: 1 == 1 Type: C Volatile: N
Direct
Inverted
Direct
-
10.30 DI6Invert (invert digital input 6)
Inversion selection for digital input 6:
0 =
Direct
1 =
Inverted
Int. Scaling: 1 == 1 Type: C Volatile: N
Direct
Inverted
Direct
-
10.31 DI7Invert (invert digital input 7)
Inversion selection for digital input 7:
0 =
Direct
1 =
Inverted
Int. Scaling: 1 == 1 Type: C Volatile: N
Direct
Inverted
Direct
-
10.32 DI8Invert (invert digital input 8)
Inversion selection for digital input 8:
0 =
Direct
1 =
Inverted
Int. Scaling: 1 == 1 Type: C Volatile: N
Direct
Inverted
Direct
-