9: Performance Assurance Agent
VLAN 2 ID
Second VLAN ID. When enabled, layer-2 PAA packets are encapsulated into a second VLAN. Applies only when VLAN 1
ID is enabled.
VLAN 1 Priority
First VLAN priority bits. Applies only when VLAN 1 ID is enabled.
VLAN 2 Priority
Second VLAN priority bits. Applies only when VLAN 2 ID is enabled.
UDP specific parameters
Destination IP address
The peer IPV4 Destination address.
Source UDP port
Specifies source UDP port (default 8793).
Destination UDP port
Specifies destination UDP port (default 8793).
Diff-Serv Codepoint (DSCP)
IP type of service field.
Explicit Congestion Notification (ECN)
The Explicit Congestion Notification value. (0 - 3)
VLAN 1 Priority
First VLAN priority bits.
EVC fault propagation
Enable fault propagation
Use this PAA probe's status in fault propagation.
Propagate on port
Specify the EVC client port to which the PAA probe status should be propagated. That port should be also configured to
perform EVC fault propagation for this parameter to take effect.
Continuity
Packet loss reference period
Packet loss reference period. This value needs to be at least 10 times the value of the sampling period.
Packet loss threshold
Packet loss threshold in %.
To Next Page
Loading...
