Aerotech Ensemble HLe - Chapter 2: Installation and Configuration; 2.1. Power Connections; 2.1.1. Control Supply Connections

Installation and Configuration Ensemble HLe
Chapter 2: Installation and Configuration
2.1. Power Connections
The Ensemble HLe has two AC input connectors; one for control power and a second for motor power. For a
complete list of electrical specifications, refer to Section 1.2.
N O T E : The machine integrator, OEM or end user is responsible for meeting the final protective ground-
ing requirements of the system.
2.1.1. Control Supply Connections
N O T E : This product requires two power supply connections. The Motor Supply and Control Supply
must both be connected for proper operation.
The control power supply input allows the Ensemble HLe to maintain communications if the motor power is
removed, such as in an Emergency Stop condition. The control power supply requires a minimum of 85 VAC
input to operate properly. The AC1 input is internally fused. The AC2 input is not internally fused but can be
connected to a voltage source other than Neutral if an external 2 Atime-delay fuse is used.
Although the control power supply contains an internal filter, an additional external filter located as close as
possible to the Ensemble HLe may be required for CE compliance (Aerotech recommends Schaffner
FN2080).
Figure 2-1: Control Supply Connections
Table 2-1: Control Supply ACInput Wiring
Pin Description
Recommended Wire Size
(1)
AC1 Line (L):85-240 VAC Control Power Input
0.8 mm
2
(#18 AWG)
AC2 Neutral (0V)or 85-240 VAC Control Power Input with external fuse
0.8 mm
2
(#18 AWG)
Protective Ground (Required for Safety)
0.8 mm
2
(#18 AWG)
(1) Refer to local electrical safety requirements to correctly size external system wires.
Table 2-2: Mating Connector Part Numbers for the Control Supply Connector
Type Aerotech P/N Phoenix P/N
Screw Torque
Value: Nm
Wire Size:
mm
2
[AWG ]
3-Pin Terminal Block ECK00213 1754465 0.5 - 0.6 3.3 - 0.516 [12-30]
www.aerotech.com Chapter 2 25