Agilent 7100 Capillary Electrophoresis System User Manual 63
LAN Configuration 4
TCP/IP Parameter Configuration
TCP/IP Parameter Configuration
To operate properly in a network environment, the LAN interface must be
configured with valid TCP/IP network parameters. These parameters are:
• IP address
• Subnet mask
• Default gateway
The TCP/IP parameters can be configured by the following methods:
• by automatically requesting the parameters from a network-based BOOTP
service (using the so-called bootstrap protocol), see “Agilent Bootp
Service” on page 75
• by manually setting the parameters using Telnet
The LAN interface differentiates between several initialization modes. The
initialization mode (abbreviation: 'init mode') defines how to determine the
active TCP/IP parameters after power-on. The parameters may be derived
from a Bootp cycle, non-volatile memory or initialized with known default
values. The initialization mode is selected by the configuration switch, see
Table 17 on page 64.
To Next Page
Loading...
