Agilent Technologies 7100 - Starting Your Computer and the Agilent Chemstation Software

Agilent 7100 Capillary Electrophoresis System User Manual 81
Using the Agilent 7100 Capillary Electrophoresis System 5
Controlling the Agilent CE Instrument
Starting Your Computer and the Agilent ChemStation Software
After you have switched on your computer and it has booted up, start the
Agilent ChemStation by double clicking the Instrument Online icon in the Agilent
ChemStation menu.
If you have problems starting the Agilent ChemStation, check that the
software has been properly installed. During startup the ChemStation might
ask you to update the connection settings, see Figure 12. You might suppress
this message in the future. If you want to update the instrument configuration,
select Yes. Typically, an instrument configuration must be updated for first
time use of the software, changes in the IP address or changes in the mode of
usage.
Figure 12 Instrument configuration during ChemStation startup
NOTE
In order to control the 7100 Capillary Electrophoresis instrument, the ChemStation revision
must be B.04.02 or higher.
NOTE
We recommend you install the Lab Advisor software revision B.01.03 or higher.
NOTE
Please refer to the ChemStation documentation and online help for details on installation
and configuration of the 7100 CE instrument.