64 Agilent 7100 Capillary Electrophoresis System User Manual
4 LAN Configuration
Configuration Switch
Configuration Switch
The configuration switch can be accessed on the right rear side of the
instrument. The 7100 CE is shipped with switches 7 and 8 set to ON. This
means that the instrument is set to a fixed default IP: 192.168.254.11
To perform any LAN configuration, SW1 and SW2 must be set to OFF.
Table 17 Factory default settings
Initialization ('init') mode Using default, switches 7 and 8 set to ON.
Link configuration Speed and duplex mode determined by
auto-negotiation
To Next Page
Loading...
