E Diagnostics quick reference
Wash Tips task parameters
264 Bravo Platform User Guide
Related information
Wash Tips task parameters
About this topic
The Wash Tips task washes pipette tips using a number of aspirate and dispense
actions. This topic describes the task parameters.
To run the Wash Tips task, see “Performing a task using Bravo Diagnostics” on
page 100.
Parameter descriptions
The Wash Tips task has the following parameters.
Target pressure
ME4C VARIO Vacuum Pump only
The difference between the pressure of the
outside atmosphere above the filter and the
pressure in the Vacuum Filtration Station
manifold, including the enclosure beneath the
filter.
For example, if you set the Target pressure to
600 mbar and the ambient pressure displayed
on the Vario pump is 1000 mbar, the vacuum
will remain on until the reading on the Vario
pump reaches 400 mbar.
Vent delay
ME4C VARIO Vacuum Pump only
The length of time, in seconds, to wait for the
air pressure under the filter to equalize with the
ambient air pressure.
Parameter Description
For information about… See…
Opening Diagnostics “Opening Bravo Diagnostics” on page 24
Editing the labware classes, liquid
library, or pipetting techniques
VWorks Automation Control Setup Guide
Setting up the Vacuum Filtration
Station
“Installing and setting up a Vacuum
Filtration Station” on page 114
Performing a diagnostic task “Performing a task using Bravo Diagnostics”
on page 100
Reporting a problem “Reporting problems” on page 87
To Next Page
Loading...
Need help?
General
