159
A Accessories and platepads
Setting up thermal and shaking stations (Inheco controller)
Bravo Platform User Guide
Figure
MTC Controller (front and back views)
After installing the accessory, you configure it in the Bravo profile, establish
communication, and set the teachpoint for the location.
Related information
Setting up thermal and shaking stations (Inheco controller)
About this topic
This topic describes how to configure the Bravo thermal and thermal shaking
accessories that are controlled by the Inheco Single TEC Controller (STC) or Multi TEC
Controller (MTC). The Inheco STC and MTC controlled accessories include the
following:
The STC can control a single Inheco device, and the MTC can control multiple Inheco
devices. For a detailed description of the Inheco STC or MTC, see the Inheco STC or
MTC user documentation.
For information about… See…
Configuring and teaching the Heating
Shaking Station
“Setting up thermal and shaking stations
(Inheco controller)” on page 159
Using the accessory in a protocol VWorks Automation Control User Guide
Accessory name Corresponding Inheco name
Peltier Thermal Station CPAC Ultraflat
Heating Shaking Station Teleshake 95
To Next Page
Loading...
Need help?
General
