61
4 Maintenance and troubleshooting
Routine maintenance and cleaning
Bravo Platform User Guide
Related information
Inspect moving parts to ensure
they are not rubbing against
each other.
Monthly Rub marks or noises that might
indicate rubbing
To resolve these issues, contact
Agilent Automation Solutions
Technical Support.
Verify teachpoint accuracy for
each deck location. Reset the
teachpoints as required.
Every 6
months, or
sooner
Any of the following:
• Issues when pressing on or
removing pipette tips
• Tips that appear off-center in
the wells, or inaccurate
pipetting at specific deck
locations
• Improper labware placement
by the gripper
Note: Issues other than
teachpoint accuracy can also
cause these symptoms. For
details, see “Troubleshooting
hardware problems” on page 81.
Pump Module. If applicable,
inspect the tubing. Change out
the tubing as necessary.
For instructions on routing the
tubing, see the Pump Module
User Guide.
Monthly Tube deterioration, or liquid fails
to pump or fails to drain properly
Weigh Station. If applicable,
verify that the configured empty
and full weights are still valid.
See “Setting up a Weigh Station”
on page 182 for instructions on
how to configure the Weigh
Station.
Bimonthly Deterioration of liquid-level
accuracy in reservoir
Inspection or maintenance task Schedule Symptoms
For information about... See...
Cleaning between protocol runs “Cleaning up after a run” on page 62
Cleaning the Bravo Platform “Routine maintenance and cleaning” on
page 60
Setting teachpoints “Setting teachpoints” on page 34
Reporting a problem “Reporting problems” on page 87
To Next Page
Loading...
Need help?
General
