ix
About this guide
Bravo Platform User Guide
Software version
This guide documents Bravo Diagnostics version 19.1, which is included in the VWorks
Automation Control software v13.1 installer.
The G5562A, G5563A Bravo Platform requires the following software versions at a
minimum:
• Microsoft Windows 10 64-bit operating system
• VWorks Automation Control software v13.1
The earlier model G5523A/G Bravo Platform is validated on the Microsoft Windows 7
and Windows 10 64-bit operating systems.
Related guides
Use this guide in conjunction with the following:
• G5562A, G5563A Bravo Platform Safety and Installation Guide. Describes potential
safety hazards and how to avoid them, how to install the device, and how to install
the light curtain and shields.
• Automation Solutions Products General Safety Guide. Provides general safety
information and describes potential safety hazards that you might encounter when
using Agilent Automation Solutions products. A copy of this safety guide is
included with your shipment.
• VWorks Automation Control Setup Guide. Explains how to define labware and
labware classes, liquid classes, and pipetting techniques, and how to track and
manage labware in storage.
• VWorks Automation Control User Guide. Explains how to create protocols, and set
task parameters for each device in the system.
If you are using the Bravo 96AM Head, see “AssayMAP Bravo Platform” on page 197.
If the Bravo Platform is a device in a third-party system, see the relevant third-party
system guides.
Related information
For more information about... See...
How to access different formats
of this user guide
“Accessing product user information” on page x
Reporting problems “Reporting problems” on page 87
Bravo Platform safety
information
G5562A, G5563A Bravo Platform Safety and
Installation Guide
To Next Page
Loading...
Need help?
General
