152 N9912A FieldFox User’s Guide
The preselected keywords (File, Site, and so forth) can be selected just like a
single character. These keywords can also be edited. Learn more on page 156.
The FieldFox labeler. The current filename is GF2.. The cursor is on the custom GF
keyword. The file will be saved to USB (flash drive). File Type is “Picture”.
How to move the cursor
Use the rotary knob to move cursor on the same row. The cursor will change
rows when it comes to a row end.
Use the ▲|▼ arrows to move the cursor up and down the rows.
When the current filename is complete
Press Done to save the file to the specified filename. If the filename already
exists, a warning is displayed.
Press Cancel to close the labeler without saving a file.
If the filename already exists, you are prompted to choose from the following:
o Press Yes to overwrite the existing file.
o Press Cancel to edit the filename.
Recall Files
State files and Trace + State files (*.sta) are the only file type that can be recalled
by the FieldFox.
ALL FieldFox instrument settings for ALL Modes are saved and recalled in a
*.sta file. If error correction is ON in CAT or NA Mode, then calibration data is
also saved and recalled.
To Next Page
Loading...
Need help?
General
