Agilent Technologies FieldFox N9912A User Manual

System Settings 165
 Then System Configuration
 Then Options
 Then Install Options The FieldFox reads, validates, then installs the options.
 Press and hold the power button to shutdown, then restart the FieldFox.
For more information about Licensing, see the FieldFox Service Manual at
www.agilent.com/find/fieldfoxsupport.
GPS
GPS (Global Positioning System) allows you to ‘stamp’ each data trace with your
physical position in latitude/longitude/elevation format. This can be useful when
making measurements on cell towers or other antennas at remote locations.
NOTE This feature is usable ONLY with the GPS receiver that is shipped with Microsoft
“Streets and Trips” and “AutoRoute” (versions 2010 and later). The GPS receiver
is NOT available from Agilent. Only the GPS USB receiver is used with the
FieldFox. Therefore, it is NOT necessary to purchase the very latest version of
the map software.
 GPS can be used in all FieldFox modes.
 Your GPS settings can be saved with Preferences. Learn more on page 163.
How to make GPS settings
 Press System 7
 Then System Configuration
 Then GPS
 Then choose from the following:
o OFF - Disable GPS (default setting).
o External - Enable GPS using an external, customer-supplied, USB dongle
device. When enabled, a check is made to detect a USB GPS device at the
USB connectors. When a device is detected, a search is made for satellites
overhead. The GPS works best when outdoors and in full view of the open
sky. When several satellites are found, the following screen appears and is
updated frequently:

Agilent Technologies FieldFox N9912A Specifications

General

Brand	Agilent Technologies
Model	FieldFox N9912A
Category	Measuring Instruments
Language	English