Agilent Technologies FieldFox N9912A - Power Meter Mode - Option 302

Power Meter Mode – Option 302 121
Power Meter Mode – Option 302
Power Meter measurements are made with Agilent U2000 Series USB power
sensors. Power readings are displayed on the FieldFox screen.
In this Chapter
Supported Power Sensors .................................. 121
How to Connect the Power Sensor ................... 122
Zeroing ................................................................... 122
Set Frequency ....................................................... 123
Set Scale ................................................................ 123
Set Relative and Offset Power ........................... 124
Set Display Units ................................................. 124
Set Averaging........................................................ 125
Single/Continuous ............................................... 125
Step Detection Mode ........................................... 126
Set Limits .............................................................. 126
Supported Power Sensors
Power Meter measurements are made using any of the Agilent U2000 Series
USB Power Sensors.
NOTE The FieldFox does NOT support the following U2000 Series features: External
Triggering (Time Gated Burst Power Measurement), Power Sweep Operation, and
Frequency Sweep Operation.