Agilent Technologies FieldFox N9912A - LAN Settings

System Settings 169
 Press Done to exit the Date and Time settings. The readout in the upper-right
corner of the FieldFox screen will update accordingly.
NOTE Although allowed during entry, year settings higher than 2088 will not be
changed on the screen.
LAN Settings
Configure the LAN settings to be used to communicate with the Data Link
Software. Learn more at: www.agilent.com/find/fieldfoxsupport.
LAN Settings
How to configure the LAN settings
The first three ‘Current...’ settings can NOT be edited.
 Press System 7 .
 Then System Configuration.
 Then LAN.
 Use the ▲|▼ arrows to select one of the following, then press Edit.
o Hostname Change the name that can be used to address the FieldFox if
your server supports this feature. The default hostname is generated
automatically.
o Obtain IP Choose from:
o DHCP - IP Address is assigned dynamically. If your server supports this
feature, the IP Address for the FieldFox is assigned each time it is started.
o Static - Set the IP Address manually. The Address remains until you
change it.
o Static IP Address - Enter the IP Address – including periods - in the format
nnn.nnn.nnn.nnn
o Static Subnet Mask - Enter the Subnet Mask – including periods - in the
format nnn.nnn.nnn.nnn
o Static Gateway - Enter the Static Gateway – including periods - in the
format nnn.nnn.nnn.nnn
o Apply Settings Choose from:
o Power Up The above settings take effect when the FieldFox is started.
o Now The above settings take effect immediately.