118 N9912A FieldFox User’s Guide
CPM (Channel Power Meter) Mode - Option 311
CPM uses the RF IN connector to make quick and simple power measurements
over a selectable frequency span. A power sensor is NOT required.
NOTE There are NO SCPI commands to set or control CPM mode.
In this Chapter
Set Frequency/Span ............................................ 119
The following CPM settings are identical to the standard Power Meter settings.
Learn more about these settings:
Set Scale ................................................................ 123
Set Relative and Offset Power ........................... 124
Set Display Units ................................................. 124
Set Averaging........................................................ 125
Single/Continuous ............................................... 125
Set Limits .............................................................. 126
Power Meter Settings
Connect the power to be measured to the RF IN port on the FieldFox top panel.
Select CPM Mode before making any setting in this section.
How to select Power Meter Mode
Press Mode_.
Then CPM.
To Next Page
Loading...
