Agilent Technologies FieldFox N9912A - System Settings; Default Chapter; Run;Hold

System Settings 159
System Settings
In this Chapter
Run/Hold ............................................................... 159
Preset ..................................................................... 160
Volume Control .................................................... 160
Display Settings ................................................... 160
Colors ............................................................... 161
Brightness........................................................ 161
Trace Width ..................................................... 162
Title ................................................................... 162
Full Screen Mode ............................................ 162
Edit Keywords ................................................ 162
Preferences
Language .......................................................... 163
Display ............................................................. 163
Battery Saver .................................................. 164
System Configuration
Options (Licensing) ........................................ 164
GPS .................................................................... 165
Frequency Reference Source ........................ 167
Security Level .................................................. 168
Date and Time Settings ........................... 168165
LAN Settings .................................................... 169
Erase User Data ..................................................... 170
See Also
Battery Usage .................................................... 12
FieldFox Internal Temperatures .................... 13
Run/Hold
The Run/Hold key determines whether the FieldFox sweeps continuously or
does NOT sweep, but holds the display results of the last sweep that was
performed.
Use Hold to conserve battery power or to allow you to save or analyze the results
of a specific measurement sweep.
The current sweep mode is shown on the screen as:
 Continuous
 Hold Hold
 --> is displayed while a single sweep occurs.