Domain Name
A domain name is a registered Internet name that gets translated into an IP address. You cannot set it from the front
panel or SCPI.
DNS Server
DNS (Domain Name Service) is an Internet service that translates domain names into IP addresses. The DNS server
address is the IP address of a server that performs this service.
l Normally, DHCP discovers DNS address information; you only need to change this if DHCP is unused or not
functional. Contact your LAN administrator for details.
l This setting is non-volatile; it will not be changed by power cycling or *RST.
l Front Panel:[Utility] > I/O Config > LAN Settings > Modify Settings
Then set the first softkey to Manual and press More and Primary DNS or Second DNS to enter a DNS address
using the front-panel arrow keys.
l SCPI: SYSTem:COMMunicate:LAN:DNS[{1|2}] "<address>"
l If you change this parameter, you must either press the Apply Changes softkey (front panel) or send
SYSTem:COMMunicate:LAN:UPDate (remote interface) for the change to take effect.
Current Configuration (LAN)
l Press [Utility] > I/O Config > LAN Settings to view the MAC address and current LAN configuration. There is
no equivalent SCPI command.
l If the instrument goes into remote, all LAN changes will be canceled and the display will go to a different screen.
Re-selecting the LAN Settings page will display the new settings if a LAN restart took place.
Web Interface
The instrument includes a built-in Web Interface for remote instrument access and control over LAN via a Web
browser. For details, see Web Interface.
26 Agilent Truevolt Series DMM Operating and Service Guide
To Next Page
Loading...
Need help?
General
