...................................................................................................................................................................................................
7
If Then
the chosen Port Role is Customer Port, continue with Step 11.
the chosen Port Role is Network Port, continue with Step 8.
...................................................................................................................................................................................................
8
In the Virtual Switch Information window, select Network Port and click Port
Details
.
Result: The Network Port Information window appears.
Refer to “GARP VLAN Registration Protocol (GVRP)” (p. 8-49).
...................................................................................................................................................................................................
9
Click Edit, select Network Port in Select Port Role window and then click Next.
Result: The Edit Network Port Information window appears.
...................................................................................................................................................................................................
10
Select enabled or disabled for GVRP and select enabled or disabled for STP Protocol
from the drop down list and click Ok.
...................................................................................................................................................................................................
11
Select the QoS mode. Either Default Profile or Flow Configuration are possible.
Additional info When QoS mode of a port is set to Default Profile, no rate
control is executed for the flows coming into this port.
Setting QoS mode to
Default Profile allows you to set-up your flow Pool
configuration (several steps needed) and then switch to this pool configuration with
changing the
QoS mode to Flow Configuration.
Related information For provisioning QoS refer to “Provision QoS Flow
Identification Table ” (p. 8-138).
...................................................................................................................................................................................................
12
Click on OK.
Result: The Customer/Network Port Information window is displayed.
Configuring WAN port parameters on a virtual switch
...................................................................................................................................................................................................
1
Select Provisioning → LAN Management → Virtual Switch
Traffic provisioning
Provisioning a virtual switch in spanning tree mode
....................................................................................................................................................................................................................................
8-110
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007
E ND OF STEPS
...................................................................................................................................................................................................
To Next Page
Loading...
