Alcatel-Lucent 7330 - NTP 157-1: I-211 M-H Indoor ONT

NTP 157 — Install an I-211M-H indoor ONT
NTP 157-4 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
Figure NTP 157-1: I-211M-H indoor ONT
4 If desired, mount the OPSU remotely from the ONT (DLP 161).
5 Install the battery in the indoor ONT (DLP 162).
Retain the battery with the Velcro strap provided in the battery compartment.
6 Route the power, fiber optic, coaxial, POTS, and Ethernet cables (DLP 108).
7 Connect the Ethernet cable to an RJ-45 connector (DLP 101).
8 Connect the POTS cables to the IDC and RJ-11 connectors (DLP 123).
9 Connect the coaxial cable (DLP 116).
10 If used, configure the SLID (DLP 129).
11 Connect the fiber optic cable to an OptiTap connector (DLP 124). A fully cabled
I-211M-H indoor ONT is shown in Figure NTP 157-2.
Silence
Alarm
System Status
Battery Power
Replace Battery
Auxillary Power
Battery
Emergency Use
MOCA
POTS
MGMT
NTWK
DATA
VID
FAIL
BTRY
PWR
AC/DC Power
connector for OPSU
Type F coaxial
connector
Fiber storage
tray
OptiTap adaptor
Per-terminated Ground
(via AC plug)
Battery compartment
Lug or nut and
cup washers for
optional external
ground connection
20275
OPSU
POTS
ports
Ethernet
port
TRTRTRTR
LINELINELINE
LINE
TRTRTRTR
LINELINELINE
LINE
POTS IDC