Alcatel-Lucent 7330 - Physical Connections on I-010 G-U Indoor ONT 3 FE 55284 AA Variant; I-010 G-U Leds; I-010 G-U Indoor ONT Connections

18 — I-010G-U unit data sheet
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 18-5
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Figure 18-2 Physical connections on I-010G-U indoor ONT 3FE 55284 AA variant
The I-010G-U indoor ONT supports data services from one 10/100/1000BASE-T
Ethernet port (CAT5 or better UTP cable). Full-duplex operation and
auto-negotiation between 10 Mb/s, 100 Mb/s, and 1000 Mb/s are also supported.
Table 18-4 describes the physical connections for I-010G-U indoor ONTs.
Table 18-4 I-010G-U indoor ONT connections
Note
(1)
The primary path for the earth ground for these ONTs is provided by the 12V Return signal in the
power connector.
18.5 I-010G-U LEDs
Figure 18-3 shows the I-010G-U indoor ONT LEDs. Figure 18-4 shows the
I-010G-U indoor ONT 3FE 55284 AA variant LEDs.
23696
LAN
POWER
ON/OFF
POWE
R
OPTICAL
ALARM
LAN
LED
Switch
Reset
button
LED
Switch
Reset
SC/APC connection
Ethernet
connection
Power
connection
Power
button
Note — The I-010G-U indoor ONT is suitable for connection to
intrabuilding or non-exposed wiring or cabling only.
Connection
(1)
Description
Ethernet port This connection is provided through an Ethernet RJ-45 cable. One
Ethernet connection is supported. The Ethernet port supports both
data and in-band video services.
Power This connection is provided through a power cable with a barrel
connector.
Fiber optic port The SC/APC connection is provided through a fiber optic cable.