Alcatel-Lucent 7330 - Accessing or Disconnecting from the HTTP or a CLI Interface; Prerequisites; Procedures Using HTTP Interface; ONT Activation Using SLID Procedures

6 — ONT management using an ONT interface
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 6-11
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Table 6-5 ONT activation using SLID procedures
6.4 Accessing or disconnecting from the HTTP or a CLI interface
This section shows you how to:
• access the HTTP or a CLI interface
• disconnect from the HTTP or a CLI interface
Prerequisites
The prerequisites are:
• The ONT is installed.
• The ONT is in service.
• For an indoor ONT, the first Ethernet port, which is typically labeled 1 on the
ONT, is in service.
• For an outdoor ONT, the ONT has a serial RS-232 craft interface.
• For an indoor Package C ONT, the ONT has an Ethernet port in service.
Procedures using HTTP interface
The HTTP interface is accessible through the first Ethernet port on an indoor ONT
using a computer or laptop with an HTTP client. The ONT must support an HTTP
server, and the computer must have a supported HTTP client (Web browser).
Task Procedure
using HTTP
interface
Procedure
using CLI
interface
Procedure
using
Package C
ONT HTTP
interface
Procedure
using
Package C
ONT CLI
interface
Procedure
using butt
set
Procedure
using butt
set or
telephone
for Package
D ONT
Activating an
ONT using an
SLID
To view
current SLID
settings
To view
current SLID
settings
To view
current SLID
settings
To retrieve
the current
SLID settings
——
To clear the
SLID
To clear the
SLID
——To clear the
SLID using a
butt set
—
To enter the
SLID
To enter the
SLID
To enter the
SLID
To modify
the SLID
To enter the
SLID using a
butt set
To enter the
SLID using a
butt set or
telephone
Note 1 — Contact your Alcatel-Lucent technical support
representative for a list of supported Web browsers.
Note 2 — When certain Network Interface Cards (NICs) are used to
connect to a graphical user interface (GUI) for an I-010G-A indoor
ONT, vlan 0 must be configured on the NIC to allow access to the
GUI.