Alcatel-Lucent 7330 - Safety Information

NTP 109 — Install a B-8102-A or B-8112-A ONT
NTP 109-2 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
Safety information
Read the following safety information before installing the unit.
Procedure
Use this procedure to install a B-8102-A or B-8112-A business ONT.
1 Prepare the cables at the site where the ONT will be installed (DLP 100).
2 Mount the business ONT:
a If you are not using a fiber storage compartment, see DLP 144.
b If you are using a fiber storage compartment (3EM 20293 AA) and a standard
tray mounting bracket (3EM 20425 AA), see DLP 145.
c If you are using a fiber storage compartment (3EM 20293 AA) and a class 1
storage tray mounting bracket (3EM 20425 AB), see DLP 146.
3 Review the connection locations shown in Figure NTP 109-1.The B-8102-A is the
identical to the B-8112-A ONT shown, however it does not have an F-type coaxial
connector.
Danger 1 — Hazardous electrical voltages and currents can cause
serious physical harm or death. Always use insulated tools and follow
proper safety precautions when connecting or disconnecting power
circuits.
Danger 2 — Make sure all sources of power are turned off and have no
live voltages present on feed lines or terminals. Use a voltmeter to
measure for voltage before proceeding.
Danger 3 — Always contact the local utility company before
connecting the enclosure to the utilities.
Danger 4 — Observe all local and national laws and regulations that
may be applicable to this installation.
Warning 1 — The earth bonding terminal shall be connected to an
approved earth connection before the ac power is applied.
Warning 2 — This equipment is ESD sensitive. Proper ESD protection
must be used when entering the TELCO Access portion of the ONT.
Note — See the ONT technical specification documentation in the
B-8102-A and B-8112-A unit data sheet for the temperature ranges.