5 — VoIP overview
5-82 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
Statistics collection using OMCIv1
Statistics collection using OMCIv1 is not available for Package C, D, E, I, or K
ONTs, with the exception of I-240G-U, I-240G-R and O-240G-P, which support
limited call history statistics. The I-240G-U, I-240G-R and O-240G-P ONTs support
only the Date, Time, Duration, Called Number and Calling Number statistics.
VoIP call statistics for the last incoming or outgoing call are retained at the ONT.
You can view the statistics from a management session with the P-OLT using TL1
or the EMS interface.
Collection of call statistics occurs when a bearer channel is established. If multiple
bearer channels are established during the course of a single call, such as if call
waiting occurs, then only the data from the last disconnected bearer channel is
retained in the ONT.
Table 5-17 lists the VoIP call statistics that are collected.
Table 5-17 Collected VoIP call statistics using OMCIv1
Note — Call record log statistics are created only when a dialog
progresses to an RTP session. Inbound no-answer calls are not logged
because an RTP session is not configured while outbound calls are
being logged.
Type Description Statistic Format/unit
Date
(1)
The date when the call was initiated. This is determined at
the start of ringing when terminating a call (incoming), or
when going off-hook for the originating call (outgoing).
DATE YY-MM-DD
Example: 06-01-16
Time
(1)
The time when the call was initiated. This is determined at
the start of ringing when terminating a call (incoming), or
when going off-hook for the originating call (outgoing).
TIME HH-MM-SS
Example: 13-30-02
Duration The duration of the call is recorded as an integer in seconds.
For a call origination, the duration starts at the initial
off-hook and stops when the call ends with on-hook. For call
termination, the duration starts when ringing is applied to
the line, continues when the line goes off-hook, and stops
when the call ends with on-hook.
DURATION seconds
Called number
(2)
(3)
For outgoing calls, the called number is the digits dialed by
the subscriber.
For incoming calls, the called number is the identity of the
subscriber line terminated at the ONT that is receiving the
call.
CALLEDNO a string of up to 25
alphanumeric
characters
Calling
number
(2)
(3)
For outgoing calls, the calling number is the identity of the
subscriber line terminated at the ONT that is initiating the
call.
For incoming calls, the calling number is the phone number
or identity of the external party that is calling a subscriber
line terminated at the ONT.
CALLINGNO a string of up to 25
alphanumeric
characters
RTP packets
transmitted
(4)
The total number of RTP packets transmitted during of the
call.
TXPKTS integer
RTP packets
received
(4)
The total number of RTP packets received during the call. RXPKTS integer
(1 of 2)
To Next Page
Loading...
