Alcatel-Lucent 7330 - Procedure 6-9 to Disconnect from the CLI Interface; Procedure 6-10 to Retrieve Product Information for an ONT

6 — ONT management using an ONT interface
6-18 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
Procedure 6-9 To disconnect from the CLI interface
1 Type X or x for Exit from the SLID menu at any time during the session.
2 Perform one of the following:
a If you are connected to the CLI interface through a craft port, disconnect the
serial cable from the RS-232 connector.
b If you are connected to the CLI interface through an Ethernet port,
disconnect the Ethernet cable from the Ethernet port.
3 STOP. This procedure is complete.
6.5 Retrieving product information for an ONT
Product information about an ONT includes the vendor name, firmware, type of
ONT (mnemonic only), and serial number.
This section shows you how to retrieve product information for an ONT.
Prerequisites
The prerequisites are:
• The user access level of the ONT is read-write.
• The steps to access the interface are completed.
• See Procedure 6-1 for HTTP interface using the first Ethernet port.
• See Procedure 6-4 for CLI interface using the first Ethernet port.
• See Procedure 6-6 for HTTP interface for Package C ONTs
Procedures using HTTP interface
The following procedure provides the steps to retrieve product information using the
HTTP interface.
Procedure 6-10 To retrieve product information for an ONT
1 From the Web-Management System window, click on the Product Information
tab, as shown in Figure 6-6.
Figure 6-6 Main options in the Web-Management System window
The Product Information window opens with the product information for the
ONT, as shown in Figure 6-7.