5 — VoIP overview
5-36 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
Analog local network profile
Table 5-12 lists the analog local network profile parameters. When OMCIv2 support
is yes, then TL1 can be used to configure equivalent parameters on systems
supporting OMCIv2.
Table 5-12 Analog local network profile provisioning parameters
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
permanent_time
r
PermanentTime
r
The duration, in seconds, of the
“permanent” timer (sometimes
known as the “start dial” timer). This
timer starts when an off-hook
condition is detected on the POTS
line, and if it expires before any
digits are received from the POTS
line, permanent treatment is applied
to the line. This is an optional
parameter. This is a non-zero
positive integer and the value is
expressed in seconds. The default
value is 16.
YYAll Yes but no
TL1 or CLI
developed
Value is
derived
from
FTP/defau
lt line
profile.
N/A
interdigit_timer
InterDigitTimer
The duration, in seconds, of the
standard interdigital timer. This
timer starts after a digit is received
from the analog line interface, and if
it expires before another digit is
received, dialing is assumed to be
completed. This is an optional
parameter. This is a non-zero
positive integer and the value is
expressed in seconds. The default
value is 16.
YYAll No, value
is derived
from
FTP/defau
lt line
profile.
N/A
critical_timer
CriticalTimer
The duration, in seconds, of the
“critical” interdigital timer. This
timer starts at a point in digit
collection specified by the dialing
pattern, and if it expires before
another digit is received, dialing is
assumed to be completed. This is an
optional parameter. This is a
non-zero positive integer and the
value is expressed in seconds. The
default value is 4.
YYAll Yes but no
TL1 or CLI
developed
Value is
derived
from
FTP/defau
lt line
profile.
N/A
(1 of 4)
To Next Page
Loading...
