Alcatel-Lucent 7330 - Service Data Set; Service Data Provisioning Parameters Per Port

5 — VoIP overview
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 5-43
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Service data set
Table 5-14 lists the service parameters per port. When OMCIv2 support is yes, then
TL1 can be used to configure equivalent parameters on systems supporting OMCIv2.
Table 5-14 Service data provisioning parameters per port
dtmf_volume_le
vel
Specifies the volume field sent in the
RFC 2833 packets that encode DTMF
from the attached phone. When the
parameter is set to measured, then
the volume of the tone received in
dBm0 from the attached phone will
be reported in the RFC 2833 packets.
When the parameter is set to an
integer between 0 and 55, then that
value will be used in the volume field
of any transmitted RTC 2833 packets
signaling DTMF. The default is
measured.
NYAll
except
package
C, D,
and E
No, value
is derived
from
FTP/defau
lt line
profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameter
(5 of 5)
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
digit_map
DigitMap
A mandatory pattern that guides
digit collection and allows the
user agent to determine when
dialing is complete. One
digit_map setting is supported
for each POTS port. See Table
5-15 for a description of the digit
map contents. This is a string of
up to 1093 characters and is a
required parameter with no
default value. A digit map must
be customized for each SIP
implementation based on the
features of the SIP server in the
network.
White space in the digit map
string is not significant.
Characters are case insensitive.
Some devices use MGCP formats.
Contact your support
representative for more
information.
For I-240W-S ONTs, all lines
should be configured to use the
same digitmap.
YYAll Yes N/A
(1 of 30)