Alcatel-Lucent 7330 - NTP 124-1: I-010 G-P Indoor ONT Connections; NTP 124-2: I-020 G-P Indoor ONT Connections

NTP 124 — Install an I-010G-P, I-020G-P, and an I-040G-P indoor ONT
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 NTP 124-3
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
4 Place the indoor ONT unit:
a On the flat surface, such as a desk, horizontally resting on its four feet as
shown in Figure NTP 124-1; go to step 5.
b On a wall (DLP 122).
5 Review the connection locations as shown in Figures NTP 124-1, NTP 124-2,
and NTP 124-3.
Figure NTP 124-1: I-010G-P indoor ONT connections
Figure NTP 124-2: I-020G-P indoor ONT connections
Note — The I-020G-P and I-040G-P cannot be stacked with another
ONT or with other equipment. The ONT mounting requirements are:
• allow a minimum 100 mm clearance above the top cover
• allow a minimum 50 mm clearance from the side vents
• do not place any heat source directly above the top cover or below
the bottom cover
20689
PWR
RESET
GE
P
OWE
R
OPTICAL
LAN
UP
DATE
ALARM
Power
connector
Reset
Ethernet
(GE)
RJ-45
ALARM
20687
PWR
P
OWE
R
GPON
ETHERNET
UPDATE
GE
GE
Power
connector
Ethernet
(GE)
RJ-45