Alcatel-Lucent 7330 - I-040 G-R ONT Hardware Limitations; I-040 G-R Indoor ONT Hardware Limitations

24 — I-040G-R unit data sheet
24-10 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
I-040G-R ONT hardware limitations
Table 24-12 lists the hardware limitations for the I-040G-R indoor ONT when
configuring services.
Table 24-12 I-040G-R indoor ONT hardware limitations
Default Ethernet flow and wildcard Ethernet flow coexisting on the same Ethernet port is not
supported
Maximum of 16 service flows (VLANs) can be enabled with pbit translation
Service classification by Ethertype is not supported
The first time an ONT is connected, the initial Ethernet UNI is enabled by default. This Ethernet UNI
can be disabled by the OLT.
When pbit translation is enabled, each GEM port can only translate into one pbit. Mapping
downstream Pbits to different GEM ports is the only form of supported pbit translation.
Static multicast is not supported
IPTV multicast over PPPoE (from the multicast port) is not supported
PM counter is partially supported
Pbit translation following DSCP to pbit mapping is not supported
Pbit translation when a UNI is set to pass through any VLAN ID (unisidevlan=4096 and
networksidevlan=4096) is not supported
Packet loss occurs in 1G wirespeed. Due to the additional 4-byte routing tag, throughput is less than
1G for all packet lengths.
Weighted round robin (WRR) is not accurate when configured with OMCI because the weight
definition in BL device is the reverse of OMCI definition
For WRR scheduling, bandwidth is not used by a queue can not be claimed by any other queues
Up to eight extended VLAN rules per VLAN port is supported
AES key can not be changed locally on an ONT
100M half is not supported
As of R4.3.00 and later, the ONT supports stacked VLAN iBridges mode. With a stacked VLAN iBridge,
in addition to performing bringing operations, the ONT supports when the ISAM can add/remove a
VLAN header to customer upstream or downstream traffic, which allows support for different
broadband access solutions.
Considerations and limitations
(2 of 2)
Limitation Parameters
(1)
Service
I-040G-R ONT must be enabled for port-to-port
communication to support the flexible mode. In this
communication mode, a business service can only be
configured on port 1, and the service is replicated on the
other enabled ONT UNI ports.
proftype
p2penable
QoS
ONT
(1 of 2)