24 — I-040G-R unit data sheet
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 24-11
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Note
(1)
See Operations and Maintenance documentation for the I-040G-R for information on these
parameters.
The following are not supported:
• both VLAN translation and VLAN pass-through on traffic
using the same p-bit across the same UNI
• VLAN translation when networksidevlan is 4096 and
unisidevlan is 0 to 4094. Upstream traffic is classified
and forwarded as pass-through traffic. Downstream
traffic is not translated to the unisidevlan setting.
unisidevlan HSI
networksidevlan Flow
Downstream p-bit translation is not supported when the
flow is configured for VLAN pass-through. In this case, the
following applies:
• a flow with networksidevlan 4096 and unisidevlan 4096,
will pass downstream p-bits to the UNI unchanged
• a flow with networksidevlan and unisidevlan set to the
same value (0 to 4094), will pass downstream p-bits to
the UNI changed to the highest p-bit value specified by
the PQ profile
When all of the following apply, the highest UNI-side p-bit
value defined in the p-bit translation profile is used:
• unisidevlan is 0 to 4094 and networksidevlan is 0 to
4094, or unisidevlan is 4096 and networksidevlan is
4096
• pbitxlprofid/nm is not 0
• p-bit translation is not defined for the downstream
p-bit in the p-bit translation profile
unisidevlan HSI
networksidevlan Flow
pbitxlprofid
pbitxlpofnm
Limitation Parameters
(1)
Service
(2 of 2)
To Next Page
Loading...
