5 — VoIP overview
5-22 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
Notes
(1)
The clientid parameter is used as the H.248 message identifier (MID) field for H.248 signaling messages when DHCP is
disabled.
(2)
DHCP Option 90 is not supported on package C and D ONTs.
(3)
DHCP Option 61 and 90 are not supported on I-240W-S ONTs.
(4)
DHCP Option 66 is not supported on package C (except I-010G-Q, I-010G-S, and I-240W-U), package D (except I-240W-S,
I-241W-S, and I-240W-Q 3FE 52958 AY variant), package E, package I, package J, or package K ONTs.
(5)
If the ONT is configured to use DHCP and the DHCP server used by the ONT supports DHCP Option 100, the ONT will get
time zone and daylight savings settings from the DHCP server. DHCP Option 100 takes precedence over configuration by
TL1 and CLI of the time zone offset.
(6)
DHCP Option 120 is supported from R04.8.48 on some devices. Contact your Alcatel-Lucent technical support
representative for more information.
Configuration profile
The system uses embedded or downloaded configuration profiles for both the voice
gateway and Megaco softswitch modes. This is also supported for SIP and includes
additional SIP-specific parameters.
Configuration profile in voice gateway and softswitch modes
The ONT supports configuration profiles related to different countries. The profile
settings for analog and digital data are specific to each country. Embedded or
downloaded configuration profiles have the same content and format, and are used
for both voice gateway and H.248 Softswitch modes.
The ONT software load contains embedded configuration profiles with the specified
file names. Embedded configuration profiles are needed when a file download is not
desirable. See the appropriate ONT Customer Release Notes for information about
the countries that are supported in the embedded profiles.
50 IP address of VoIP
service on the ONT
Not recommended Supported Supported Supported
61
(3)
ONT client ID Not recommended Supported
(1)
Supported Supported
66
(4)
FTP server’s IP address
(used if FTP download
is needed)
Not recommended Supported Supported Supported
90
(2)
(3)
DHCP authentication Not recommended Supported Supported Supported
100
(5)
Time zone offset Not applicable Not applicable Supported Supported
120
(6)
IP softswitch IP
addresses or domain
name
Not recommended The first IP address
is the primary
server. The second
IP address is the
address of the
secondary server.
If a second IP
address is present,
it enables
redundancy.
Supported Supported
DHCP option Function Voice gateway
mode
H.248 Softswitch
mode
SIP mode 1
(for IPoE)
SIP mode 2
(for IPoE)
(2 of 2)
To Next Page
Loading...
