Alcatel-Lucent 7330 - Retrieving RSSI; Procedure 6-17 to View RSSI

6 — ONT management using an ONT interface
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 6-29
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Procedures using HTTP interface for Package C ONTs
Not applicable.
Procedures using CLI interface for Package C ONTs
Not applicable.
Procedures using butt set
Not applicable.
6.8 Retrieving RSSI
The RSSI is the recorded measurement of the ONT receive optical signal at 1490 nm
in dBm. This feature is available for RSSI-capable ONTs only.
This section shows you how to retrieve the RSSI measurement for an ONT.
Prerequisites
The prerequisites are:
• The user access level of the ONT is read only or read-write.
• The ONT is RSSI capable.
• The steps to access the interface are completed.
• See Procedure 6-1 for HTTP interface using the first Ethernet port.
• See Procedure 6-4 for CLI interface using the first Ethernet port.
Procedures using HTTP interface
The following procedure provides the steps to view the RSSI measurement for an
ONT using the HTTP interface.
Procedure 6-17 To view RSSI
1 From the Web-Management System window, click on the States Management
tab, as shown in Figure 6-13.
Figure 6-13 Main options in the Web-Management System window
The ONT status window opens with the ONT states and their current status, as
shown in Figure 6-10.
2 Click on the RSSI tab. The RSSI window opens with the current RSSI measurement,
as shown in Figure 6-14.