Alcatel-Lucent 7330 - VEIP Configuration Inputs

5 — VoIP overview
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 5-17
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Figure 5-6 shows VEIP configuration inputs.
Figure 5-6 VEIP configuration inputs
Figure 5-7 shows dual SIP upstream and downstream tagging.
Modify an ONT VEIP port After the ONT UNI port is created, you cannot modify the
association between an ONT UNI port and a QoS session profile. To
associate a new QoS session profile with the ONT UNI port, you
must first delete the ONT UNI port and re-create it.
The ONT UNI port must be in the out-of-service state to modify
any parameter other than customer information.
If you specify a new non-default DSCP to p-bit mapping profile,
the profile must exist.
Delete an ONT VEIP port To delete the ONT UNI port, the following is required:
• All services and flows that are configured on the port must be
deleted.
• The ONT UNI port must be in the out-of-service state.
Task Restriction
(2 of 2)
VEIP
VEIP
MAC Bridge
Service
Profile
PPTP
POTS UNI
UNI-G
UNI-G
PPTP
POTS UNI
VLAN
Tagging
Filter
VLAN
Tagging
Filter
Ext VLAN
Tagging
Oper
Priority
Queue A1
(Downstream)
Priority
Queue A2
(Downstream)
Priority
Queue A3
(Downstream)
Priority
Queue A4
(Downstream)
MAC Bridge
Port Config
Data
MAC Bridge
Port Config
Data
MAC Bridge
Port Config
Data
GEM
Interworking
TP
GEM
Interworking
TP
802.1p
Mapper
Service
Profile
802.1p
Mapper
Service
Profile
GEM
Interworking
TP
GEM
Interworking
TP
22218