Alcatel-Lucent 7330 - Reboot Window; Tracing OMCI and Protocol Traffic; Procedure 6-27 to Reboot a Package C ONT; Procedure 6-28 to Reboot a Package C ONT

6 — ONT management using an ONT interface
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 6-43
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Procedure 6-27 To reboot a Package C ONT
1 Select the Reboot option from the ONT Admin section of the navigation tree in the
GPON ONT window.
The Reboot window appears; see Figure 6-25.
Figure 6-25 Reboot window
2 Click Reset to reboot the system.
3 STOP. This procedure is complete.
Procedures using CLI interface for Package C ONTs
The following procedure provides the steps to reboot an ONT using the CLI interface
provided with Package C ONTs.
Procedure 6-28 To reboot a Package C ONT
1 Type R or r for Reboot from the SLID menu at any time during the session.
2 STOP. This procedure is complete.
Procedures using butt set
Not applicable.
6.13 Tracing OMCI and protocol traffic
Tracing is a logging of traffic to detect or resolve networking problems. Trace logs
are normally provided to support staff for troubleshooting. You can trace OMCI,
ARP, DHCP, or IGMP protocol traffic.