Alcatel-Lucent 7330 - SFU Cabling with and Without Moca; Planning Maintenance; Monitoring

2 — Part numbers, ordering, and deployment configuration overview
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 2-47
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Figure 2-5 SFU cabling with and without MoCA
Switching existing services from a service provider can be a challenge. For example,
an existing copper network interface device may be many feet away from the ONT,
while the coaxial splitter may be at the opposite end of the premises. In this case,
some of the options are:
• Install the ONT on top of the existing network interface device and use the ONT
as the new network interface device.
• Run copper and coaxial jumpers from the ONT to the network interface device
and the RF splitter.
New housing and MDU developments provide an opportunity to optimize the wiring
design to support the offered services. The options include:
• specifying a central wiring and cabling closet or box
• installing the ONT indoors and running fiber directly to the ONT from the outside
2.6 Planning maintenance
This section provides information about planning ONT maintenance.
Monitoring
The system provides maintenance tools. The 5520 AMS can be used to monitor
alarms and performance. In addition, TL1 and CLI commands can be used at the craft
terminal at the OLT or the ONT/MDU (if supported) to perform monitoring tasks.
Monitoring alarms and performance provide some troubleshooting, but do not
provide the granularity needed for fault isolation.
19441
SFU customer premise
ONT
UPS
PC
TV
TV
PC
CAT
CATCAT
IP video
New cabling
IP
video
Coax
Coax
SFU customer premise w/MOCA
ONT
UPS
PC
PC
CAT
CAT
DC power
MOCA
MOCA
MOCA
TV
TV
DC power