6 — ONT management using an ONT interface
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 6-57
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Procedures using HTTP interface
The following procedures provide the steps to view the current SLID settings, to
clear the SLID, and to enter the SLID at the ONT using the HTTP interface.
Procedure 6-38 To view the current SLID settings
1 From the Web-Management System window, click on the SLID Management tab,
as shown in Figure 6-32.
Figure 6-32 Main options in the Web-Management System window
The SLID window opens with the current SLID settings, as shown in Figure 6-33.
Figure 6-33 SLID window
where the SLID settings are described in Table 6-11
2 Click on the Refresh button to refresh the contents of the window.
3 STOP. This procedure is complete.
Note 1 — To enter or clear a SLID using an Ethernet connection, the
ONT must be disconnected from the PON optical cable.
Note 2 — You cannot change the SLID settings when the ONT is
connected, ranged, and provisioned.
To Next Page
Loading...
