23 —  I-021G-P and I-241G-Q unit data sheet
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 23-5
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Figure 23-2  I-241G-Q indoor ONT physical connections
Table 23-4 describes the physical connections on I-021G-P and I-241G-Q indoor 
ONTs.
Table 23-4 I-021G-P and I-241G-Q indoor ONT physical connections
Note
(1)
The primary path for the earth ground for these ONTs is provided by the 12V Return signal in the 
power connector.
23.5 I-021G-P and I-241G-Q LEDs
Figure 23-3 shows the I-021G-P indoor ONT LEDs. 
Connection 
(1)
Description
Ethernet ports This connection is provided through Ethernet RJ-45 cables. For the 
I-021G-P ONT, up to two 10/100/1000 Base-T Ethernet interfaces are 
supported. For the I-241G-Q ONT, up to four 10/100/1000 Base-T 
Ethernet interfaces are supported.
The Ethernet ports can support both data and in-band video services on 
both interfaces. 
RF video coaxial This connection is provided through an F-Type coaxial connector.
POTS connections 
(I-241G-Q ONT only)
This connection is provided through an RJ-11 phone connector. Up to 
two POTS interfaces are supported. 
Power This connection is provided through the power connector. A power 
cable fitted with a barrel connector is used to make the connection. 
Fiber optic This connection is provided through a SC/APC fiber optic connector. 
The fiber optic connector is located behind a fiber optic port cover on 
these ONTs. 
GE1
GE2
RESET
RF
PWR
PWR
TEST
GPON
VIDEO
LAN
POTS
Ethernet
ports
Reset
button
Power
connector
Fiber optic
connector
F-Type
coaxial
POTS
ports
22657
GE1
GE2
POTS1
P
OTS2