Alcatel-Lucent 7330 - Page 383

5 — VoIP overview
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 5-37
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
timed_release
TimedReleaseTi
mer
The duration, in seconds, of the
Timed Release timer. To end a
conversation, the local or remote
subscriber hangs up. If the local
subscriber hangs up, BYE is sent to
the softswitch immediately unless
this was a termination end of the
call. If the local call was the
termination call, BYE is not sent and
the idle state is entered until the
re-answer timer expires or BYE is
received. The re-answer timer is
configured using the reanswer_timer
parameter.
This is an optional parameter. This is
a non-negative integer and the value
is expressed in seconds. The default
value in the XML file is 10 seconds.
The default is 10 for TL1.
YYAll Yes TL1 using
RLSTIMER using
ed-ontvoiceport
sip
CLI using
rlstimer
using
configure voice
ont
voice-sip-port
enter_key
EnterKey
The digit that is to be treated as an
indication that dialing is complete,
when received at a point in digit
collection where it does not match
the dialing pattern at that point. This
is typically used to signal the
completion of dialing a speed dialing
number or an international number.
This is an optional parameter. The
hash mark symbol “#” is the default
value.
Other devices always use #.
YYPackage
A, B, H
only
No, value
is derived
from
FTP/defau
lt line
profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(2 of 4)