Alcatel-Lucent 7330 - Page 384

5 — VoIP overview
5-38 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
resanswer_timer Specifies the reanswer timer.
The default value is a string
use_timed_release. You can also use
a non-negative integer to indicate
the reanswer timer value. A value of
0 causes the user agent to send a BYE
immediately upon on-hook.
In the case of an integer, the timer
governs the following behavior. On
an inbound call, if the analog line
goes on-hook, the User Agent
maintains the dialog and start the
reanswer_timer. The media session
remains active with the user agent
transmitting RTCP packets as usual,
and silence if the current audio
format requires, and receiving audio.
If the analog line goes off-hook
before the timer expires, the analog
line resumes participation in the
media session of the dialog, and the
timer is canceled. If a BYE is received
before the timer expires, the user
agent idles the analog line and
cancel the timer.
If the timer expires with the line
remaining on-hook, the User Agent
idles the line and end the dialog by
sending a BYE. A value of 0 will cause
the User Agent to send BYE
immediately upon on-hook.
NYPackage
A, B, H
only
No, value
is derived
from
reanswer_
timer XML
value
N/A
error_tone_time
r
This parameter is a string containing
either a non-negative integer value
or the text use_timed_release. The
options are used_timed_released
(default) and a non-zero integer.
If the parameter has an integer value
then the value governs the time, in
seconds, that tones are generated in
response to INVITE errors before
starting permanent signal treatment.
If the parameter is set to
use_timed_release timed_release
parameter has a value of 0, the timer
is set to 10 seconds. If the
use_time_release value is used, then
BUSY is the only error condition
whose duration is governed by the
timed_release. All other errors will
result in immediate permanent
signal treatment.
NYPackage
A, B, H
only
No, value
is derived
from
timed_rel
ease XML
value
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(3 of 4)