Alcatel-Lucent 7330 - Page 404

5 — VoIP overview
5-58 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
obsolete_stale This value controls the behavior
of the ONT with respect to nonce
expiration and re-registration or
dialog refreshes.
If this value is set to “true” then
if the ONT receives an
authentication reject (401 or 407
error) that contains a new nonce
value, but no stale-flag, the ONT
should behave as if a stale=true
was present and send the refresh
with the new nonce value
Note that the ONT will still
properly handle the stale-flag, if
present. If the obsolete_stale
value is set to “false”, then if the
stale-flag is not present in the
401/407 message, RFC2716
compliant behavior will be
followed, and the registration or
dialog that was being refreshed
will be terminated. The default
value is “false” when using FTP
download and “true” when using
iConfig to configure SIP.
All lines of I-240W-S ONT should
be configured the same.
YYPackage
A, B, H,
I-240W-
S ONT
only
No, value is
derived
from
FTP/default
line profile.
N/A
thin_client_HF_met
hod
If the voice client is in thin mode
(SIP mode 1), the flash hook
processing behavior is controlled
by this value.
If the value is set to ‘info’, the
hook flash indication is sent
using an INFO message to the
softswitch. If the value is set to
‘invite’, the ONT passes the HF
event to the softswitch using an
INVITE message with the
request-URI set to the value of
the thin_client_HF_request_URI
value.
All lines of I-240W-S ONT should
be configured the same.
YNPackage
A, B, H,
I-240W-
S ONT
only
No, value is
derived
from
FTP/default
line profile.
N/A
thin_client_HF_requ
est_
URI
This value contains the string
value to be used as the user
portion of the INVITE request
when the ONT is in thin client
(SIP mode 1) and the
thin_client_HF_method is set to
‘invite’. The default is
‘LucentTISPAN-FlashRequest’.
All lines of I-240W-S ONT should
be configured the same.
YNPackage
A, B, H,
I-240W-
S ONT
only
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(16 of 30)