Alcatel-Lucent 7330 - Page 415

5 — VoIP overview
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 5-69
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
etsi_3wc_release_la
test
Specifies the code used to
reduce a three-way call to a
two-way call by releasing the
last added call. Valid values are
in the form Rd, where d is 0-9, *,
or #. The default is an empty
string. You can only configure
the parameter when the
enable_etsi parameter is set to
true.
All lines of I-240W-S ONT should
be configured the same (* and #
are not supported on the
I-240W-S ONT).
YYAll
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
enable_3wc_focus Specifies the behavior of the
ONT when generating contact
name in an INVITE of a second
call. The options are:
• true (default)
• false
When set to true, the ONT
appends 3WC to the contact
name and adds the isfocus
header. If the three-way call is
reduced to a two-way call, a
re-invite is sent to remove the
isfocus.
When set to false, the ONT does
not append 3WC to the contact
name and does not add an isfocus
header to the invite message.
You can configure the parameter
when the enable_etsi parameter
is set to true
NYAll
except
package
C, D, E,
and
I-240W-
S ONT
No, value is
derived
from
FTP/default
line profile.
N/A
prefer_early_media Specifies whether to continue to
output early media to a user
even after the ONT receives a
180 ringing response.
The options are:
• True/1/Yes to ignore the 180
ringing response
• (default) False/0/No to
suppress the early media
session and play a local
ringback tone
This parameter is available in
XML releases R4.1 and 4.3, but
not R4.2.
All lines of I-240W-S ONT should
be configured the same.
NYAll
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(27 of 30)