NTP 113 — Replace a G-010V-P ONT
NTP 113-2 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
Safety information
Read the following safety information before replacing the unit.
Procedure
Use this procedure to replace an G-010V-P ONT.
1 Deactivate the ONT services (DLP 131). If you are using the SLID feature, this step
is not required. The ONT and the services can remain in service (IS).
2 Disconnect the VDSL and power cables, if required, from the ONT; see
Figure NTP 113-1.
Danger 1 — Contact the local utility company before you connect the
enclosure to the utilities.
Danger 2 — Observe the local and national laws and regulations that
may be applicable to this installation.
Warning — This equipment is ESD sensitive. Proper ESD protections
should be used when removing the fiber access cover of the ONT.
Caution — Keep indoor ONTs out of direct sunlight. Prolonged
exposure to direct sunlight can damage the unit.
Note 1 — The ONT should be installed in accordance with the
applicable requirements of the NEC or CEC. Local authorities and
practices take precedent when there is conflict between the local
standard and the NEC or CEC.
Note 2 — The ONT must be installed by qualified service personnel.
Note 3 — Indoor ONTs must be installed with cables that are suitably
rated and listed for indoor use.
Note 4 — See G-010V-P detailed specifications in the G-010V-P unit
data sheet for the temperature ranges for ONTs.
To Next Page
Loading...
