NTP 133 — Install an I-010S-P indoor or O-010S-P outdoor ONT
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02 November 2013 NTP 133-3
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
5 Connect the fiber optic cable to the ONT with the SC/UPC connector.
6 If used, configure the SLID (DLP 129).
7 Activate and test the services (DLP 128).
8 STOP. This procedure is complete.
Warning — Be careful to maintain a bend radius of no less than 1.18
inches (3.0 cm) when connecting the fiber optic cable. A bend radius in
the cable that is too small can damage the optic fiber.
To Next Page
Loading...
